Dimensions of Stanley 46 Cutters
I just purchased a Stanley 46 plane with no cutters. Before I drop ~100$ on some very nice reproduction cutters I was thinking of trying to make a few myself. I have some 1/8th O1 steel that I bought for making some custom cutters for my 45 & 55.
I have read that the long-side angles are ~20 degrees and the lower/short side angle is ~29 degrees.
Does anyone have the dimensions of original 46 cutters? How long are they? I know the length isn’t critical since there is no fine-depth adjustment like on the 45/55 but I would like them to match any originals I might get in the future.
The 1-1/2 inch filletster cutter has a curve on the upper left side. Does anyone have the approximate dimensions of that? I assume that cut-out curve is to accommodate the skate and/or fence?
Regards,
Phil