Hi all,
I have a Hugo made by hurricane lasers. (Chinese). Uses a reci tube.
I cut 1/4" acrylic on a regular basis and have always gotten nice smooth cuts. The jobs I do run for about 25 minutes. I use 5 speed and 87 power in Lasercut 5.3. I am getting very jagged edges now on the cuts. When I do a small test cut (2-5 min job). The cuts are smooth. When I do a large 25min job they are jagged. It seems as though the cuts at beginning of job are decent and then gets worse as time progresses.
Any ideas what could be causing this? My gut thinks the tube is going out? I went ahead and order a new tube and should get it in a week or so.
Thanks for any help!
Dave