[OP]
Member
Hi all
I have a V logo Stanley/Bailey Plane iron that is showing delamination. I have ground off nearly 1/2 inch and there still appears to be a line of delamination. Have any of you seen this problem? Is there a way to fix this, or should I just toss it.
Thanks
Contributor
If it is useless, it may as well be tossed.
If the lamination can be peeled off and saved it may be useful for making a marking knife.
jtk
"A pessimist sees the difficulty in every opportunity; an optimist sees the opportunity in every difficulty."
- Sir Winston Churchill (1874-1965)
[OP]
Member
Hi Jim, I think it will have to be trashed. I tried to separate it but it comes off in pieces. Thanks
Contributor
That is too bad.Originally Posted by Mark R Webster
Maybe if the logo can be cut out and turned into a pin you could sell it on ebay and make enough money to buy a new PM v-11 blade.
jtk
"A pessimist sees the difficulty in every opportunity; an optimist sees the opportunity in every difficulty."
- Sir Winston Churchill (1874-1965)
[OP]
Member
Hmmm
Posting Permissions
Reply With Quote