-
Can't do a whole lot, right now......have a small "creek" going across the shop floor.....had a "Gulley Washer" come through town.....basement where the shop is....has a ground water problem in heavy rain storms...
Will update when things dry out a bit...(at least the drain worked great...)
-
Modified the top of my bench....for a little while...
IMG_5182 (640x480).jpg
Didn't want anything to roll away and hide...
IMG_5183 (640x480).jpg
Old shaft was torn down...had rings, key stock and a few other things that didn't need to roll away
IMG_5184 (640x480).jpg
Bearings looked good, spacer did too...rings will be good for now....the shaft?
IMG_5185 (640x480).jpg
Laying beside it's replacement...even the keyways were too worn to hold the keys in place....took a while, but got things back together
IMG_5186 (640x480).jpg
Then installed in the saw..
IMG_5187 (640x480).jpg
Wheels were installed....1/4" blade added...AFTER I ran just the wheels for a bit...then rechecked the set screws to make sure they were tight
IMG_5188 (640x480).jpg
Haven't swapped out the motors, yet. The Craftsman one is starting right up, no issues...for now.
IMG_5191 (640x480).jpg
This may have been the cause of a lot of the troubles?
I still may swap out the motors...no rush right now...
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules