I've been using a Diablo (home depot) 10" combination on my Bosch jobsite. Great blade and many of the cuts are glue ready.

Finally powered up my craigslist 3hp Unisaw find and need blades for it. The thin kerf diablo blade I don't think will work with the sharkguard riving knife setup I have, certain I need full kerf.

I was looking at a Freud Industrial Glue Line Rip and their combination blade. Went to buy the combination blade at Rockler but it was $20+ more than amazon. Their glue line rip was only $4 dollars more than amazon.

I'm ok getting 2 blades right now. Would a combination and glue line blade be a good start? I'm just a hobby guy cutting hardwood for cutting boards and house projects.

I do have lots of 2"x3" apitong I'll have to cut through. Not sure what I used for that. The diablo combination on my bosch saw would not make it through the apitong.