Due to the fact these things use fiber optics, and the hand-held versions of these I see all over, I THINK these options are possible, but I'm not at all sure
Here's my fiber laser, side view:
Front view:
============
I'm wondering if I can do either
THIS---
or
THIS?
=======================
My immediate problem is, I need to engrave a 4" logo in the center of an 18" x 24" part. From the edge of the machine itself to the max Y coordinate I can engrave is 8". The plate centerline is 9"Y, plus half the 3" height of the logo.
Ideally, rotating the head and the whole machine sideways would be great! I could hang a small kitchen cabinet from the ceiling to set the machine in/on... Then, I could engrave virtually anything I could place under the thing! Floor or table space would be the only limitation--
So-- possible?