A used machine is in the back of my mind Brad...it may be the best way to go. And Kevin...very sage advice. Thank you both.
A used machine is in the back of my mind Brad...it may be the best way to go. And Kevin...very sage advice. Thank you both.
build your own. Check out openbuilds.org
It is a woeful mistake to assume that Vectric software is not capable of very sophisticated high end design projects just because it is low cost and easy to use. That is why they dominate the CNC router software market.
I found an interesting article while researching a problem I was repairing on my machine. I think there is a lot of truth to paying too much attention to some details and not enough to the others. I posted a link in case you are interested.
http://www.hainesengineering.com/rha...info_speed.htm