I was just playing around with cutting out a leather key chain fob and found it difficult in Corel to draw a shape. So I used my CAD system which is Alibre and drew up the part and made a DXF file and imported it into the Corel software. Went to cut with the laser and it cuts each section of the complete path in an odd order, jumps all around, does a line, then opposite side of the part does and arc, then back to another side and does another line and so on. Eventually gets it all done, but how do I get the DXF file to cut in a continuous path? Do I "weld" the DXF file together before I send it to the laser? Something else I'm missing?