Bud, thanks for the input. I just installed a .5 micron from wynn filters, I'm really happy with it especially when comparing it with the original felder felt bag.
Bud, thanks for the input. I just installed a .5 micron from wynn filters, I'm really happy with it especially when comparing it with the original felder felt bag.
Ok, as I understand it the Magnehelic model 2005 0-5 pressure gauge will measure up to 5 inches of water pressure (positive pressure). How does inches of water correlate to PSI (or is it the same)? I want to mount one on my new Wynn nano filter before I start using it to keep tabs on its loading so I know when to clean it. I have a small shop (16x18) that I am setting up 5/6" dust collection ducting now using a single stage 1.75 HP DC. If I mount to the top metal part of the Wynn cartridge filter, how do I keep the little tube that goes to the gauge from getting clogged? Randy
Last edited by Randall J Cox; 05-31-2016 at 9:24 AM.
Very nice Ben.
You can also build a manometer with a length of 1/4" clear tubing and some water in it...........Rod.
Thanks to your help, I got my gauge up and running.
I noticed my gauge was bouncing around a lot, I fixed it by plugging the 1 extra high port, low port, and slightly plugging the second low port.
Also if you think your gauge is not working because it won't leave "0"... open a blast gate. duh. damhikt
Nicely done Dan! Just out of curiosity what did you use to plug the unused ports?
If at first you don't succeed, redefine success!
Ben
The gauge comes with 2 pipe plugs (1/8" or 3/16" npt) I scavenged another plug off a broken air regulator.
OK, my Magnehelic 2005 gauge just arrived, bought off ebay. Gauge goes to 5 in of water. Don't have it hooked up yet. Probably will tap off top of filter, hopefully won't get plugged with sawdust. At what positive pressure should I consider cleaning filter (pleated Wynn nano)? Randy
Oneida says at 3" of pressure. Mine with a new filter and 2 blast gates open runs at 1.25". After filling the drum once, it was up to a little over 1.5".
Jason
Jason, ok, good to know, thanks. Randy
He's referring to this: 2 came with my guage.
https://www.amazon.com/Dixon-Valve-B...d+hose+fitting
Got it all hooked up. With new filter, Magnehelic gauge just jiggles a little barely off 0 while running. It does work as I blew into it through the connection tube before connecting. As nano filter is brand new, guess its all working like it should. Thanks for all the info and help to all on this. Randy
Jason, yes I did. I verified it was working properly by blowing into it before installing. Thanks. Randy
I just installed one of these yesterday after seeing it here. Mine is on an Oneida 2.5 hp cyclone with older non-HEPA filter. I had the dreaded filter with chips and dust phenomenon recently and cleaned up the filter with compressed air. So, it is pretty clean. The gauge reads about 0.7, so not even 1. I attributed it to relatively clean filter.