Good evening everyone. I have a question regarding how small in dia. a log can be to be worth milling. Some background info. I have a lot of oaks on my property that are any where from 6" to 18" in dia. at the base. The wood would be for my own use. I currently mill the logs on my vertical bandsaw setup. The main question would be what is the minimum dia. log for milling? I just milled some logs that were between 8 - 10" in dia but there wasn't much lumber when I was done. Time is not an important factor but I don't want to saw up smaller trees if it is not worth it. Any ideas or suggestions?