After you cut a board from a log, what are your steps to the eventual stickered stack?
As you cut, do you sticker immediately, or do you cut and put boards into a dead stack, and then when finished sawing, then sticker?
If you have a kiln do you pick up the stickered stack with some forks and set the whole shebang into the kiln? Or, perhaps you take your dead stack and sticker inside the kiln?
After kiln drying, do you store your wood in the kiln if you don't have any new boards to load into the kiln?
After kiln dying, do you sticker the boards outdoors or move them inside and perhaps dead or vertically stack them?