Page 1 of 2 12 LastLast
Results 1 to 15 of 26

Thread: Reporting Shoddy Electrical Work

  1. #1
    Join Date
    Jul 2007
    Location
    Fort Wayne IN
    Posts
    1,210

    Reporting Shoddy Electrical Work

    Where can I report this? Is there an agency that can look at them? I became aware of some work that was done that could have set the house on fire. This work was done by a licensed HVAC installer. I do plan on uploading the pictures to Angie's List with a complaint. After their work here, I am shocked at the good reviews they got there.

    Thanks
    Sometimes decisions from the heart are better than decisions from the brain.

    Enjoy Life...

  2. #2
    Join Date
    Feb 2003
    Location
    McKean, PA
    Posts
    15,649
    Blog Entries
    1
    Have you addressed the quality of the work with the installer?
    Lee Schierer
    USNA '71
    Go Navy!

    My advice, comments and suggestions are free, but it costs money to run the site. If you found something of value here please give a little something back by becoming a contributor! Please Contribute

  3. #3
    Join Date
    Nov 2007
    Location
    NW Indiana
    Posts
    3,086
    I would document the issue and then contact the installer first. If that did not resolve issues, I would contact your local building inspector and discuss it with them.

    I would be a little careful and make certain of everything before putting it all on the internet. I think Angies list is careful how they handle problems like yours do to the lawsuit potential.

  4. #4
    You should contact the company first. It is more than likely the installer was in a hurry to get done. Give the company a chance to make it right.

  5. #5
    Join Date
    Jun 2006
    Location
    The Hartland of Michigan
    Posts
    7,628
    Quote Originally Posted by Larry Frank View Post
    I would document the issue and then contact the installer first. If that did not resolve issues, I would contact your local building inspector and discuss it with them.
    ^^^^This^^^^
    Crying Wolf is no way to do it.
    Never, under any circumstances, consume a laxative and sleeping pill, on the same night

  6. #6
    Join Date
    Jan 2009
    Location
    Lexington, TN
    Posts
    461
    Quote Originally Posted by Raymond Fries View Post
    Where can I report this? Is there an agency that can look at them? I became aware of some work that was done that could have set the house on fire. This work was done by a licensed HVAC installer. I do plan on uploading the pictures to Angie's List with a complaint. After their work here, I am shocked at the good reviews they got there.

    Thanks
    Raymond, who says the work could have caused a fire? Did anyone get permits or have inspections done on the work? It's much more trouble to address poor work after the fact than during the process. I would image everyone is blaming someone else for everything, and nothing is getting resolved.

    I recall when you started the work on your house adding windows and the mini split system and all the problems that you have had with so many areas of this. Frankly it seems like everyone involved with it has performed poorly and compounded your problems. Where any building and electric permits obtained and the work inspected? The long list of issues I have read you having with your project is a big reason why I try to do everything I can myself. I know there are good people "out there" that take pride in the work they do and see it as a reflection of themselves ( I am one of them) yet there are also people who will do the bare minimum or less and get by for years doing what many perceive to be good work when they honestly wouldn't know a good job from a poor one if it slapped them in the face. If I do it, I know how it was done, and who to look to if something goes wrong, and I am getting my training at my own expense rather than pay someone else to learn. Come backs are rare for me because I am "curious" and usually go to extreme to prevent future problems.

    I am hoping for a good outcome for you in all of this. I think you have had more than your share of problems that really could have been prevented by the right people.
    Universal Laser ILS 12.150D (48"x24") 135 watts total, with 60 watt and 75 watt laser cartridges. Class 4 Module (pass thru ability). Photograv 3.0, Corel X6, Adobe Design Standard CS4 Suite, Engrave Lab laser Version 8, Melco Single Head Comercial Embroidery Machine, The Magic Touch System with Oki C711WT printer, and Graphtec CE6000-60 plotter.

  7. #7
    HVAC techs aren't electricians and should only be making final connections. At least in Wisconsin. So (for example), if you're adding a heat pump outside, an electrician is required to install the circuit and outside disconnect, and the HVAC guy is allow to connect to that disconnect.

    So what I'm saying is, there isn't a lot of opportunity to do shoddy work when you're just making a final termination.

    So what was done?

    If it was an obvious attempt to circumvent the requirement to use a licensed electrician, I think I'd contact the electricians union.

  8. #8
    Join Date
    Jul 2007
    Location
    Fort Wayne IN
    Posts
    1,210
    The heating contractor that installed the dehumidifier in the garden room first installed defective heat tape (the blue one) and the external drain line froze last winter. At this time, they chose their plan to run the line outside instead of running the drain line through the attic. When they came to fix the frozen line, they ran another heat tape inside the PVC pipe and said they would come in the spring and do the final fix. This heat tape was connected directly to the dehumidifier and ran 24/7. The wires exited the unit through the sheet metal side of the unit by leaving some screws loose. I discovered this burned spot a month ago. I sent the heat tape1 picture to them expressing my concern and there was no response from them about this.
    HeatTape1.jpg


    They sent they installation manager out and he decided to run the line through the attic. He never said anything about the heat tape.

    In dealing with the garden room leak, I needed to pull the dehumidifier from the back wall and remove the baseboard for my water testing.

    These pictures are what I found when I pulled the drain line from the wall. Part of it was so brittle it broke pulling it from the wall. We decided we do not trust the work of these contractors. We are asking for a refund and to have them pick up the equipment. We will look to another contractor for a solution.

    HeatTape4.jpgHeatTape3.jpgHeatTape2.jpgHeatTape5.jpg

    Looks like a fire hazard to me.
    Sometimes decisions from the heart are better than decisions from the brain.

    Enjoy Life...

  9. #9
    I'm not sure you can get them in trouble for that. Stupid, crappy job, no doubt. But nothing that probably hasn't been seen repeated elsewhere a few hundred thousand times.

    Allowing HVAC techs to spec-out how the work will be performed can be a bit like gambling. Some of them are undoubtedly very bright and conscientious. Others probably had difficulty passing the 608 exams.

    Try to do your research and figure out the best way to achieve your goal before hiring a contractor. Extra work, requires joining HVAC forums, etc., but when you're done you will know how to spec-out the work so the guy you hire gets it right.

  10. #10
    Join Date
    Jul 2007
    Location
    Fort Wayne IN
    Posts
    1,210
    Good advice Phil. We have until winter before the dehumidifier will be needed.

    Mike - I am with you on trying to do everything myself. I will be so glad when we are on the other side of this mess.

    Thanks all for your comments.
    Sometimes decisions from the heart are better than decisions from the brain.

    Enjoy Life...

  11. #11
    Join Date
    May 2005
    Location
    Highland MI
    Posts
    4,523
    Blog Entries
    11
    Quote Originally Posted by Phil Thien View Post
    If it was an obvious attempt to circumvent the requirement to use a licensed electrician, I think I'd contact the electricians union.
    Seriously, the union? Many licensed qualified electricians are not union. I don't see where that would get you. To answer the OP's question, if a complaint is in order, I would start at the building department to determine if a permit was needed and if so was it pulled. And if so, was the work inspected, and if so, did the specific "hazard" get passed by the inspector.

    That being said, I doubt that installation of heat tape is something that requires a permit and inspection. My guess is that the installer didn't follow the heat tape manufacturer's requirements and the beef is with the installer. The OP may want to send the photos to the heat tape manufacturer for an opinion.
    Last edited by Ole Anderson; 06-25-2015 at 11:52 AM.
    NOW you tell me...

  12. #12
    Join Date
    Jan 2009
    Location
    Lexington, TN
    Posts
    461
    same on going mess you've been dealing with for months.

    One just has to wonder if the way your installation has been done is the standard way they do them all. As I recall from previous post about the drain freezing. I think the water was actually freezing in the pipe in the ground when it got cold enough for the ground to freeze then backing up and blocking the drain line elbow that was ended over the pipe in the ground. Heat tape never would solve that problem, but I suppose wrapping the drain coming out of the wall and later installing heat tape in that pipe would keep the condensation from freezing in the pipe were it could run out.

    I thought months ago, the drain was never done in a way that could be problem free. This is my point about doing things. Think of what you can do now to avoid problems later. You are already working on it now, so why not take a little extra precautions and have a trouble free FOR LIFE job.

    keep us posted on how this goes Raymond
    Last edited by Mike Lassiter; 06-26-2015 at 8:54 AM.
    Universal Laser ILS 12.150D (48"x24") 135 watts total, with 60 watt and 75 watt laser cartridges. Class 4 Module (pass thru ability). Photograv 3.0, Corel X6, Adobe Design Standard CS4 Suite, Engrave Lab laser Version 8, Melco Single Head Comercial Embroidery Machine, The Magic Touch System with Oki C711WT printer, and Graphtec CE6000-60 plotter.

  13. #13
    Quote Originally Posted by Ole Anderson View Post
    Seriously, the union? Many licensed qualified electricians are not union. I don't see where that would get you.
    You're probably right.

  14. #14
    Join Date
    Nov 2011
    Location
    South Bend IN 46613
    Posts
    843
    I don't really know much about code but to me it does not look like the electrical code has been violated. However if I hired an electrician and he or she did work like this I would kick them to the curb pretty fast and not pay the bill. I have done most of my own wiring so far in my life and am pretty particular about how it looks when I am done and my wife is actually concerned about not burning the house down.
    [SIGPIC][/SIGPIC] "You don't have to give birth to someone to have a family." (Sandra Bullock)




  15. #15
    Join Date
    Sep 2009
    Location
    Medina Ohio
    Posts
    4,534
    from your pictures why are you complaining about shoddy electric install that is heat tape that plugs into an electric outlet. that would fall under HVAC inspections.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •