Calling all Hammer Owners

[Derek Cohen]

Hi Derek,
Thanks for posting the pictures..I like the Incra for the F/F jig... And I happen to have an old Incra fence and Shop Stop around that I can use. Wondering how you attached the Incra fence to the board below it-- I assume you just drilled through the bottom of the fence, but thought I would ask if there was some other clever way you came up with that wasn't obvious in the photos-
Thanks,
Izzy
(Regards from Northern California!)

Hi Izzy

Just screwed the fence down through the slots at the bottom of the channel. Nothing mysterious there

Regards from Perth

Derek

[Izzy Charo]

Hi Derek,
Thanks...I must have a different version of the fence, but easy enough to figure out a solution...
Izzy

[Izzy Charo]

Update: With the help of the photo from Chris Parks and some further instructions from Felder I did manage to get the Fine Adjustment on and working... Really appreciate the help that folks on this Forum offer. Chris- I very much like the DRO that you have set up on the rip fence bar/head. Next time you're in your shop if I'd love a picture or two of how you mounted it on the Hammer.
Thanks again,
Izzy