Results 1 to 4 of 4

Thread: Maker of this dovetail saw?

  1. #1

    Maker of this dovetail saw?

    Howdy, I'm hoping one of you will recognize this logo stamped on the right side of the back of an offset-handle dovetail saw. I have rubbed chalk in the imprint to make it show up better, but the stamp didn't make a full impression, so it probably needs previous acquaintance to recognize it.

    NNGO saw logo.jpg
    Thanks for looking.nng co saw.JPG

  2. #2
    Join Date
    Jan 2009
    Location
    Williamsburg,Va.
    Posts
    12,402
    Can't read it,but those type saws I have seen were all German.

  3. #3
    Join Date
    Nov 2006
    Location
    Sebastopol, California
    Posts
    2,319
    Strictly speaking, it's less likely to be a dovetail saw than a trimming saw. If the teeth are unset on the side opposite the handle, it's for trimming off plugs, dowels, and other stuff that winds up proud of the surface.

  4. #4
    Yes, that makes sense. There is very little if any set and it certainly is made for trimming.

    Thanks

    Jim

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •