Results 1 to 3 of 3

Thread: coolant/cleaners in tube water

  1. #1

    coolant/cleaners in tube water

    OK I've seen so much controversy on this subject, wondering what folks here think. My machine is in the garage where it gets really cold, past freezing if I don't watch it and heat. So what do folks think of the motorhome antifreeze, regular antifreeze..... and also difference between distilled vs. deionized water.

  2. #2
    Well your going to get the same controversy here some will say its ok to use anti freeze some will say don't do it. I was warned that it would void my warranty if I used it. So I don't. I'd advise you search here to get the info cause its a beated subject and no one want to talk about it since theres so much info already here good luck
    If the Help and advice you received here was of any VALUE to you PLEASE! Become a Contributor
    Rabbit RL_XX_6040-60 watt Laser engraving/cutting machine Oh wait its a 3D Printer my bad LOL
    Lasercut 5.3
    CorelDraw X5

    10" Miter Saw with slide
    10" Table Saw
    8" bench mount 5 speed Drill Press
    Dremel, 3x21 Belt Sander


  3. #3
    Here's a recent discussion that might help:

    http://www.sawmillcreek.org/showthre...uestioin/page2

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •