Hi I recently changed my laser from a 50W to a 60W tube I had a problem and managed to damage my power supply for the tube. I changed out this also and the laser has never been cutting better but I have a small problem when I want to do light engraving I am getting too much power it wont fire under less than 6mA. I can use the manual power setting on my laser engraver to get this down to 3mA and this is a good setting for me my tube fires at about 2.4mA.
I need to figure a way to get the power down to a lower power without using the manual override on the machine any ideas would be greatly appreciated.