Hello folks.

I have a 40 watt Zing and would like to run the 75 dpi test to see where along my tube is. I came across this while searching and have searched to try to get more specific info.

I have made a 100% black square and I am ready to raster it on a piece of black anodized aluminum. Now here is where the noob comes out. When I made the template in Corel, I made the rendering resolution to 75 dpi. Was it here that I put the 75 dpi or do I leave it at 300 and change the dpi in the epilog dashboard? If it is to change it in the dashboard how do I change it to 75 dpi? The lowest I can go is 100 dpi.

I am sure that I am missing the obvious.

Thank you all for your help.

Allan