I've just go back into woodworking after a decade or so. I wanted to use my Inca shaper with a 1 1/4" spindle to make some window moldings. When I found the profiles I wanted in the Amana catalog, they were 1/2 or 3/4 inch bore. I don't have any other spindles nor does it appear that the 1 1/4" spindle can be removed from the Inca. I'm not about ready to buy a second shaper. What I did notice was that the Amana catalog had 186 pages or router bit as opposed to 42 for shaper cutters. Are people moving to table mounted routers to do light duty molding? I have a very nice heavy duty Festool router, but no table for it. Since I'm working out of my garage, I'm trying not to bring in any new equipment if can make do with what I have. I have another shaper cutter catalog that has the cutters I need, but I haven't ordered from them in over twenty years and I haven't checked to see if they are still around.