I recently acquired a Jointech Saw Train router table with the rails, Sliding Bridge Assembly and Jointech Clincher and Smartfence. The table measures 3 feet wide by 4 feet long. This was originally attached to a table saw. I had to remove the components in order to get them in my SUV.

I have reassembled everything as a stand alone router table and have questions as to the proper way to set everything back to functioning properly.

Does anyone on the Creek have a Jointech Saw Train and could offer me some guidance as to the correct clearance of the Sliding Bridge Assembly and fence to the table surface or have a manual/instructions to set this up?

Thanks as always.

Roger in Texas