As the post says, I am looking for a 2 5/8 ID 90 degree elbow for dust collection from my Delta bandsaw. Any help wpould be appreciated.
[OP]
Member
As the post says, I am looking for a 2 5/8 ID 90 degree elbow for dust collection from my Delta bandsaw. Any help wpould be appreciated.
Contributor
Go to a muffler shop where they bend the exhaust pipes and they may be able to do it for you...
Your local NAPA store will probably be able to tell you where one is locally..
Contributor
You never know, the NAPA store might have something.
Never, under any circumstances, consume a laxative and sleeping pill, on the same night
Member
2-5/8" ID is 2-3/4 OD if the wall is 1/16". That's some really thick exhaust tubing, but a coupe wraps of electrical tape would make up the difference. Most auto parts store fittings are going to to have rough bends. You really want mandrel bent tubing if you go that route. This one's crazy expensive for what you want, but available. http://www.jegs.com/i/Dynomax/289/41...FUdgMgodt3wAhA
Posting Permissions
Reply With Quote