Hi guys, I'm running a Trotec Speedy 300 80W (purchased new in early 2013) cutting 1/8" delrin with 40+ hours per week cutting time. 90% of time vector cutting, with a lot of rapid movements for small thru holes, etc. I found I was adjusting Mirror 2 about once per week, and Mirror 1 about once every 3 weeks. And of recent, it seems I'm having to adjust even more often. I contacted Trotec tech support, and they stated this was unusual, most customers rarely do alignments, if ever. I believed the tech support rep.
My hunch is that the brass alignment screws are not staying put. So I've added a healthy dob of red loctite to the alignment screws on Mirror 2 and Mirror 1 (this was in addition to the factory-applied red loctite that I've long since broken/screwed past).
Can Trotec Speedy 300 operators please chime in with their typical re-alignment intervals. Or if you've tackled this problem in the past, how'd you fix it?
Thanks all!