Results 1 to 3 of 3

Thread: Dust Collection Positions for SLiding Compound Niter saw

  1. 07-21-2013, 4:25 PM #1
    tim walker
    tim walker is offline [OP] Contributor
    Send a message via Yahoo to tim walker
    Join Date
    Apr 2004
    Location
    Comfort, TX
    Posts
    557
    Blog Entries
    1

    Dust Collection Positions for SLiding Compound Niter saw

    So I have built my dust shroud and am positioning it for 2-4" duct collection ports. I am hooked up to a Clearvue Cyclone so air movement not an issue. The dust shroud is 5 sided. I have placed one outlet at the rear center bottom. I am trying to decide on the second outlet. I don't know id it should go on a side down low, in the back center but higher, or out the top.

    Any suggestions form those that may have set tehre tools up?
    Reply With Quote Reply With Quote
  3. 07-26-2013, 5:45 PM #2
    James Baker SD
    James Baker SD is offline Member
    Join Date
    May 2008
    Location
    near San Diego: unincorporated section of county
    Posts
    764
    I don't have an answer, but I am interested in what others think, so I will bump this thread.
    Reply With Quote Reply With Quote
  4. 07-31-2013, 5:32 PM #3
    Andy Pogue
    Andy Pogue is offline Member
    Join Date
    Jul 2007
    Posts
    76
    Do you have pictures? I have kicked around several ideas, but haven't come up with anything I like.
    "Time flys like an arrow........ Fruit flies like a bannana."
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules