Here one of my current projects, its a bench grinder. The base and sheilds are cast aluminum, the rest is steel. started from billet aluminum, sheet steel, and a 3/4 round bar. Its almost done, but not quiet.
Here one of my current projects, its a bench grinder. The base and sheilds are cast aluminum, the rest is steel. started from billet aluminum, sheet steel, and a 3/4 round bar. Its almost done, but not quiet.
Last edited by curtis rosche; 05-02-2013 at 6:29 PM.
14x48 custom 2hp 9gear lathe
9 inch pre 1940 craftsman lathe
36 inch 1914 Sydney bandsaw (BEAST)
Wood in every shelf and nook and cranny,,, seriously too much wood!
Nicely done!
Had to subscribe to this thread so I don't miss your next installment. I can hardly wait to see the finished grinder.
Lornie
I wish I couldve taken pictures in the lab at school casting the parts and doing some of the machining, but the semester goes fast and theres not much time for that
14x48 custom 2hp 9gear lathe
9 inch pre 1940 craftsman lathe
36 inch 1914 Sydney bandsaw (BEAST)
Wood in every shelf and nook and cranny,,, seriously too much wood!
Curtis, nice job. When do you think you'll be done? ....... Jerry (in Tucson)
I have till thursday to get it done, not including paint
14x48 custom 2hp 9gear lathe
9 inch pre 1940 craftsman lathe
36 inch 1914 Sydney bandsaw (BEAST)
Wood in every shelf and nook and cranny,,, seriously too much wood!