All,
I have a Shenhui G690 with the chuck style rotary.
I am trying to do a pen that is 15mm diameter.
I am just testing by creating a 20mm x 20mm box in CorelDraw X5.
I send it RDCAM and then go into the vendor settings and change the y interval to 1 to start.
I then run the scan, after selecting rotary in RDCAM and 15mm as the diameter. I think there is a step setting here also....1000 default I believe. I left that alone.
Does not look like a box but a 20mm (x) x 2mm (y) rectangle.
So then I try multiplying the height (y) of my object in Corel by 3.14 and then to RDCAM again.
I try again to run it and the rectangle is now taller, i.e. it rotated more, but it is still not a box.
So I take the measurements and then go into vendor settings, y axis, interval, and use it's calculation with measured and intended.
For some reason it will not always take the write in vendor settings and will default back to 20mm for y axis interval. Not sure why.
Anyhow, my input is still hosed.
Any ideas?
Thanks,
Jimmy