I am using LaserCut 5.1, when I run "Clip Box" it is supposed to CUT the outside frame, however, the first side it does is at a very quick speed and does not cut, the other 3 sides are ok, any suggestions on settings??! Thanks Amos
I am using LaserCut 5.1, when I run "Clip Box" it is supposed to CUT the outside frame, however, the first side it does is at a very quick speed and does not cut, the other 3 sides are ok, any suggestions on settings??! Thanks Amos
Good better best, never let it rest, til your good is better and your better best.
Omni Pro 3000 with 80watt Laser tube
Gravograph M 20+
I don't know about LaserCut, but if you had your box directly on one of the axis in Corel, it wouldn't cut. Make sure you're box isn't directly butted up against the x or y axis.
Scott Challoner
30W LaserPro Spirit (Need more power)
30W Wisely Fiber Galvo
Thanks Scott, but no, the box isn't directly butted against the x or y axis, Amos
Good better best, never let it rest, til your good is better and your better best.
Omni Pro 3000 with 80watt Laser tube
Gravograph M 20+
Amos
I don't use LaserCut but in a lot of ways it is similar to LaserCAD, which I do use.
In LaserCAD there is the option to choose the origin. It is called "Position Relative". See Pic.
If LaserCut has something similar, does it make any difference if you select a different origin?