"Clip Box" only cutting 3 sides

[Amos De Pasquale]

I am using LaserCut 5.1, when I run "Clip Box" it is supposed to CUT the outside frame, however, the first side it does is at a very quick speed and does not cut, the other 3 sides are ok, any suggestions on settings??! Thanks Amos

[Scott Challoner]

I don't know about LaserCut, but if you had your box directly on one of the axis in Corel, it wouldn't cut. Make sure you're box isn't directly butted up against the x or y axis.

[Amos De Pasquale]

Thanks Scott, but no, the box isn't directly butted against the x or y axis, Amos

[Greg Holt]

Amos

I don't use LaserCut but in a lot of ways it is similar to LaserCAD, which I do use.

In LaserCAD there is the option to choose the origin. It is called "Position Relative". See Pic.

If LaserCut has something similar, does it make any difference if you select a different origin?