So i have been doing allot of looking around for coin blanks. I found a USA based company that was able to work with me. Rather than tell me that they do not sell blanks...... I was actually pretty surprised in all the No's i got. So i found a company that said they had some blanks sitting around. They are coins that are .093” thick x 5.80” Dia – currently only steel parts.[COLOR=#1F497D][FONT=Times New Roman]..... So they are going to send me a few blanks. It is probably a bit smaller than what i am looking for. But when i get them i will take pictures. If i decide i like them he will give me a price roll out. It is thicker than a penny. Thicker than a Nickel. If it is made out of steel it will be heavy. I think this company will provide me with a good sample. I can take photo's of the blanks if need be.
The only problem is i have to order a minimum of 3,000 units. So it might be a bit expensive.. But when u look at the cost per unit. I am sure it will come out good.... They will be highly polished with a nice edge. Since i expect my lasers to last about 10 plus years i think it would be safe to say that i can order some and have permanent inventory. The coins were sent through a Large Drum polisher for 4 days.........Awesome !!!!!!