This is the smallest Disston saw I have seen. I am thinking it may have been a toybox saw? Does anyone know know anything about this 12 inch saw?
tinysaw.jpg
This is the smallest Disston saw I have seen. I am thinking it may have been a toybox saw? Does anyone know know anything about this 12 inch saw?
tinysaw.jpg
If it is the Buddy "L" saw, my understanding is collectors will pay a lot for those as it is most commonly the missing component of their Buddy "L" tool box.It's a Disston Buddy "L", Moline, Illinois, tool box saw for children.
jtk
"A pessimist sees the difficulty in every opportunity; an optimist sees the opportunity in every difficulty."
- Sir Winston Churchill (1874-1965)
Hey - that's the perfect size for me! (I'm barely joking - my panel saws are only 6" longer...and I'd have preferred 16" long ones)
I'm not convinced that the OP's saw is a Buddy L. Check out one of my posts from last years on this subject:
http://www.sawmillcreek.org/showthre...y-newest-Buddy
You are right, Joe. Sorry, Joe, Larry—my bad—I did not click on the thumbnail. And thanks for pointing out my error, Joe.
The earlier Disston No. 28 tool box saw was later re-conceived and marketed as the Buddy L and finally as the Disston American Boy Saw, all which are too often (and erroneously) called Buddy L saws.
Of the different versions/etchings, the Buddy L is often considered the most collectible due to crossover interest, but there are far more saws than tool boxes to go around so tend to be fairly low performers auction-wise, even among Buddy L collectors. There was even a presentation model with extra saw nuts and a darkened handle.
On looking again at my own example and comparing it with the blow-up of Larry's saw, mine has the the more detailed wheat handle with three saw nuts—clearly not the same. Again, sorry, Larry.
At one time, you couldn't swing a dead without hitting one of these in New England junk, 'antique' stores and swap meets when I lived there.
For an American Boy 'ad', scroll about half way down:
http://www.disstonianinstitute.com/ads.html
Last edited by David Barnett; 03-03-2013 at 10:17 PM.
David,
So glad things unfolded the way they did in this thread, else I would never have gotten the information you shared on the Buddy L's.
Now I'm off to find one of those "presentation" models
David,
Would the presentation saw be for Buddy L executives, and/or valued customers, or could it have been custom-etched for other organizations?
The look is reminiscent of the Victory saws which had rosewood handles and nickle-plated brass fasteners.