I purchased a Freud FT3000-VCE a few years back when they first came out. I'm not sure if this is still covered under warranty as I can't find my receipt. Used it a couple of times and it pretty much sat in a shop made table collecting dust. I recently bought an Incra Super System with the intention of using the Freud. After mounting the router on the plate and putting it in the table I tried to rasie the router to do a bit change. I could not get the router high enough, or the base low enough to engage the spindle lock with the lever. Checked my stops and the turret stop is out of the way, the plunge lock is not engaged but I'm about 1/2" - 3/4" from getting the lever to meet the spindle lock pin. Anybody else have this issue?