While this isn't a turning tool necessarily, turners experience / advice is what I need so...

I am looking for a new chainsaw as my poulan is finally biting the dust (I am doing a happy dance on the inside) and I have decided to go with a Stihl. Now... when I was discussing what I wanted/used it for(processing logs for turning and some yard cleanup on a 5 acre wooded lot), the dealer was recommending a MS391/20in. bar.

Is this going to be "too much" saw?

In searching the forum, when I found posts that noted the saws used/purchased, typically the saws were smaller than what I am looking at. So, I am a little un-decided. The budget is already approved as the wife was watching when I was working over a piece of walnut last weekend.


Thanks!