laserworks and dot cut

[Tom Schulze]

Has anyone successfully used the dot cutting feature in laserworks to perform cutting similar to the other machines that have PPI settings?

Please share results if you would.

Tom

[john banks]

Yes to produce perforations or to reduce the power to engrave paper in vector mode.

No to get any benefit in cutting performance or acrylic edge finish.

[Tom Schulze]

John, would you mind sharing your settings for paper cutting? thanks

Yes to produce perforations or to reduce the power to engrave paper in vector mode.

[john banks]

I did perforations using 1mm each for the two dot lengths.

For vector engraving paper I used 50mm/s speed, 8% power and IIRC 0.1mm each for the dot length and interval.