Unifence installation update

[Steve Ash]

A few weeks ago I got a unifence (a partial Valentines day gift from my better half) and someone asked to give a report on how it went together. My computer has been down since then and I am using the local library computer, so I am sorry not answering sooner. The installation was very easy, I attached it to my Delta contractors saw. The only glitch was my own fault, it says to set the measuring tape at "O" which I thought was even with the saw blade. It actually lines up with the cast iron edge of the saw table. The whole installation process may have taken 2 hours max. It sure is a very nice addition to my table saw.

[Michael Pfau]

Hi Steve, I have the unifence as well, and love it. The only thing that I have to remember is which curser to look at, whether the fence is upright or lying down!! for the most part I use mine lying down, it gives you more room for a push stick, and keeps your hand further away from the blade. Enjoy!

[Corey Hallagan]

Congrats and enjoy the Unifence! It should make a huge difference for you!

Corey

[Kelly C. Hanna]

Congrats on the new fence!