I just upgraded to x6 and have found a few irritating nitnoys that I haven't been able to resolve.
When opening an old x4 file, the color palette becomes CYMK even though it was RGB in the original file and I saved x6 document properties to default to RGB (new files created in x6 do use RGB). How do I make x6 open the x4 files with their original RGB mode?
The transformation docker sometimes initially opens showing size as 1.0, 1.0 rather than the actual size of an object as shown (correctly) in the object size widgets on the top toolbar. Once it starts showing the real size (e.g., because I type in both values and apply), I've not seen it show this bogus info again during an edit session. Any body else seen this or know how to fix?
Speaking of the transformation docker and apply, the most irritating and annoying problem I've had is that, in x4, I could pick a reference point (e.g., center, bottom left, etc.), type in a number for, say, X or Y size into the transformation docker, and hit enter to make the new size take effect. However, in x6, hitting enter after typing in a number just reverts to the original value so I have to remember to click on the Apply button without pressing enter. Using enter is an ingrained habit and this keeps biting me. Anyone know how to change this behavior to allow using enter?
-Glen