inlace use

[paul wiser]

any one have any input on using epoxy with inlace instead of their hardener?? any info appreciated. thanks

[Lori Kleinberg]

I use inlace with 2 part epoxy (5 minute). I mix the inlace with part A until totally smooth. Then add part B (hardener). Mix well and when it starts to thicken I fill the form. Overfill, then sand down after it hardens. You might need to tap a bit after filling to remove air holes.

[paul wiser]

thanks for your input. it will be very helpful. i am going to be doing inlays on cheese and cutting boards and wanted to use inlace or some other crushed gemstone material. thanks again