I finally got to work on a SCMI SC600 bandsaw restoration this weekend. The machine needed tires, guides and a phase converter/VFD. The blade wheel adjustment mechanism was frozen and I received generous help from Rick Fischer who went out of his way to share his experience and help (A big thanks). I ordered OEM tires, a TACO Westinghouse VFD, and Laguna guides. I installed the tires but have not touched the VFD yet. When installing the guides, I realized the Laguna lower guide does not fit properly. When I put it straight, the side supports off by about 1/2 inch regardless of whether it is installed below or above the shaft that holds it. The only way it can possibly be centered and have any clearance on each side of the blade is if it is installed slightly diagonally as in the attached picture. In this case the side supports are not against each other. The problem with this configuration is that it is impossible to adjust the rear support as the side supports are in the way. If anyone used the Laguna guides and share experience/ideas that would be great.