Recently I grumbled on this list about the limitations of my Craftsman table saw. With some good advice from here and elsewhere it's to a point of meeting my needs. (Biggest improvement was adding a face to the fabricated steel fence and shimming it straight and perpendicular.) My next step would be poly-v sheaves and belt.
Recently I picked up a mid 80s Jet contractor saw clone ("JTS-10"). For $25 it has a motor, tubular fence rails and not much else. The blade and (iron) pulleys run true and the table is flat. "1.5" hp TEFC motor.
If I fix up this saw will it be an upgrade to the Craftsman?
Looks to me that a Delta Jetlock fence (for 1 3/6: rails) might well fit. Anybody have one around to sell?
Thanks for any guidance.
am