I'm sorry if this has been discussed somewhere else in this forum. I've tried searching but it's not something that's easily found in the archives.
I'd like to make some clear acrylic tokens in different shapes about 2" square or a little smaller. On the underside of the token I want an image that I would make using a printer on photo pater, or similar product. This would be glued to the back of the acrylic then the token cut out with the laser.
Here's the question: How do I glue this image to the acrylic such that the glue doesn't blur or otherwise interfere with viewing the imagery on the attached media? What printer, ink and media do I use to prevent the glue from ruining the image as it's attached to the acrylic?
Any suggestions are very greatly appreciated.
Thanks,
Allan