Here's a real woodowrking dilema. I have a set of 4 chair in the kitchen. Nice comfy ones. When they made the legs they took them straight from the lathe and mounted them in the chairs, never bothering to bevel the bottoms so the spindles sit flat on the floor. So the legs meet the floor at a point (the corner of the spindle). I have tried all kinds of glides but they either wear out or break. Now the kitchen floor has spots worn in it where the legs rub on the floor. What I would like to do, is cut the legs so they meet the floor flat. The caviat is that they must be cut while they are still glued to the chair. I have a jointer and table saw at my disposal. I have bandsaw too, but I can't see how that would work.
I'm open to suggestions and can't wait to see what you guys come up with.