8x10 CNC Sketch

[Michael Simpson Virgina]

This is a drawing that took the CNC about 45 minutes to draw. It had 161858 Lines of Gcode.

I set the cnc to run at 100IPM but it was going to take too long so I increased the speed and it maxed out at about 280 IPM


Its a picture of my kids last Thanksgiving

[james mcgrew]

micheal, your work is gettin good!!

there is a thread (sticky) above this one named work we produce, if you post this type of info there it is held in perpetual view for all, otherwise the threads just climb to the bottom

this is some good stuff!!