butternut blank 16.5x15.5x1.1875 was machined out, 5 toolpaths incuding the graphic ,turned out ok
http://www.youtube.com/watch?v=mPdwvxjquT0
butternut blank 16.5x15.5x1.1875 was machined out, 5 toolpaths incuding the graphic ,turned out ok
http://www.youtube.com/watch?v=mPdwvxjquT0
Nice job Stan also a great video
Mick
Hardware:Software:
CAMaster 508 ATC + Recoil
2013 Trotec Speedy 100, 60 watt, rotary attachment, vector grid.
CoralDraw - Aspire 9 - EnRoute
Custom Architectural Signage
Mick Martin Woodworking
thanks for the interest i really enjoy the cnc router and laser,i used the laser to sign the back of this sign
That's terrific. Nice design and execution. Well done video. Thanks.
Richard
Nice job Stan, I too liked your video.
Mark
nice work!
Creative Woodwork and Design
Vector Studio 22
its a lot of carefull setups and with bit changes you can easily screw up a good piece if wood,also therer is a 1/2 offset on the graphic which is tricky with mach3 post processor and of course if you're not doing this every day murphy's law will kick in
Great work stan
enjoyed the video also i am new to cnc and ordered a legacy
machine that should be here in a week or so. learning from
all of you in the forums and utube. can't wait john
Impressive