Hello again first thanks very much for the help wrapping up my restore on my stanley #40 my Next project is going to be a full restore on a # 7 panel saw made by disston. Sweet small saw but needs some tlc Both horns have good size chips in them so Im just going to salvage the blade here. I dug around in my piles of scraps and was able to find a nice piece of cherry, walnut and mahogany that would be sutable for a new handle. So here is the situation. Its my first time attempting this and will obviously need to get set up with the proper tools to do it. I plan to do the handle,re-set and sharpen it. The guy I bought it from says it has 9 tpi but there is a #8 stamped under the handle so im thinking its actually 8tpi. So im thinking I need at min. A saw set, Saw file Slim or extra slim im not really sure here, and a rasp to shape the handle with I have a fret saw and a coping saw that should get the handle roughed out and a few carving chisles and knives. Any good books I should pick up or sharping tips will also be helpful.