Well, I managed to get a few days vacation, coupled with a long weekend due to Memorial Day, I have 5 straight days off! So, the first day, yesterday, was a bust. No power since 8pm Wed night when severe storms blew thru. It came back on late in the day Thur, so I didn't get anything done. It was kinda nice just listening to the breeze and sipping a cold beer...no humming, buzzing, ringing, chiming going on. Just silence for the most part. Nice.
Power's back on today, so I got to work. I started by routing the round over on the back.
Made sure to check the bearing at the neck pocket...okay.
Next, it was the control cavity. I used a template set I already had. I turned the cover so I could get the control layout I wanted...sort of upside down from how the cover is normally used. I cut the main cavity...
Then the lip for the cover. I went just a hair deeper than I needed knowing that finish buildup would bring it back flush.
Done.
"Thought that is no longer limited brings experience that is no longer limited" Marianne Williamson.