Soon, I will be getting a Woodmaster planer/molder/sander...yada yada yada.
Besides making molding, my plan was to also use it to make some flooring, because of it's flooring accessory consisting of two routers on the outfeed side, to cut the tongue and groove.
Many have suggested that instead, I purchase a dedicated shaper. Even tho it means additional handling of the boards, I think using the shaper for this task will be a wise decision.
In any event, my question is, If you had a Woodmaster, and a dedicated shaper with stock feeder...would you ever do any profiling of trim, crown molding, tongue/groove, or anything for that matter, on the Woodmaster?