I threw a 8x8x2 piece of Yellowheart on the spinny thing and waa-laa, I came up with this square thing. Man these things are a bunch of work, knuckle busters.
Finish is fraction wax and polish, though that was a little tricky while spinny.
I threw a 8x8x2 piece of Yellowheart on the spinny thing and waa-laa, I came up with this square thing. Man these things are a bunch of work, knuckle busters.
Finish is fraction wax and polish, though that was a little tricky while spinny.
Scott C. in KC
Befco Designs
Great looking piece Scott. No way would I use friction polish on it, my hand still hurts from trying to sand the one I did last week.
Great job.
Dick
No Pain-No Gain- Not!
No Pain-Good
Square bowls are fun because there are so many ways one can go with them. I like the flowing lines of this one.
What you do today determines what you can do tomorrow.
Beautiful bowl, Scott, Nice finish
Earl
I can't even get the round ones to look good. Here you are turning square ones. Looks great.
Jim
Really beautiful!!!!! Great design!!! Original!!
"All great work starts with love .... then it is no longer work"
That is FANTASTIC, Scott. Beautiful wood, revealing finish, and wonderful flowing design. Pure EYE CANDY!
Bruce
That Is a great looking piece of work..Awesome..
Beautiful ! WOW! Great design!
Very nice, Scott! I'm really starting to get green with envy over all you folks having the opportunity to crank out such nice stuff on the spinny things! On the flip side, it gives me a bit of an incentive to get all those house to-do's going! Lookin' real good Scott!
Cheers,
John K. Miliunas
Cannot find REALITY.SYS. Universe halted.
60 grit is a turning tool, ain't it?
SMC is totally supported by volunteers and your generosity! Please help if you can!
Looking for something for nothing? Check here!
Scott, Real nice looking bowl. Where are the other three to make a set?
Wes Newman
"Where did all of my money go? "
Very cool!....is this anything like turning a square wheel.....
I really like the finish and the flowing lines!
Ken
So much to learn, so little time.....
Terrific Scott! Should be just the right thing for some Holiday candy.
Kent Cori
Half a bubble off plumb
Scott,
I think you are doing quite well of late on the lathe...turning out some great pieces! You really captured a nice, pleasing, flowing shape on this bowl and with a wood that is equally clean and clear. Sometimes wood can have too much figure!!