Hey all,
I need to hook up my table saw and rather than hard wire the TS I wanted to install a power cord/receptacle for it. The TS requires a 30a breaker so I need to use 10ga wire.
Here are a couple of options I thought of:
1. A 6' dryer cord (about $10)
2. Run #10's in flexible metal conduit using the correct plug (I have everything but the plug)
3. Buy a 25' section of #10 extension cord and use less than 10ft of it and add the correct plug ($45)
4. Another option that I can't think of
The saw will be positioned in a way where the cord will be out of the way but I don't really want to take a chance on nicking the cord.
What are your thoughts?
TIA,
Doug