I have looked in all of the places that I know of and no luck so far maybe some of you have ran across it. I am going to try to up load an image of the font but it may not turn out to well as I only have a thumbnail size to go by. Thanks, Al
I have looked in all of the places that I know of and no luck so far maybe some of you have ran across it. I am going to try to up load an image of the font but it may not turn out to well as I only have a thumbnail size to go by. Thanks, Al
Al
40W MII W/Rotor
Camaster Stinger III, Vectric Aspire
Back up Vinyl cutter
Roland 54" print/cut
Laminator
Strip heater
Lasermaster 8.5, LXI Master Plus, Corel X4, Photograv, design shop pro
Knight DC16, DK3 Mug Press, Hix HD400D, GX7000
Embroidery
Hot stamping
Sorry no image..tring again.
Al
40W MII W/Rotor
Camaster Stinger III, Vectric Aspire
Back up Vinyl cutter
Roland 54" print/cut
Laminator
Strip heater
Lasermaster 8.5, LXI Master Plus, Corel X4, Photograv, design shop pro
Knight DC16, DK3 Mug Press, Hix HD400D, GX7000
Embroidery
Hot stamping
It's hard to tell for certain because the image is so small, but it looks like Zapfino Forte LT or Zapfino Extra LT
I read recipes the same way I read science fiction. I get to the end and I think, "Well, that’s not going to happen."
Yes it appears to be Zapfino.
Yes it does look like zapfino one. Thanks guys. I hate to Spend 39 bucks for a font to make a $60 sign lol. I may try to modify another font to get buy. Thanks guys
Al
40W MII W/Rotor
Camaster Stinger III, Vectric Aspire
Back up Vinyl cutter
Roland 54" print/cut
Laminator
Strip heater
Lasermaster 8.5, LXI Master Plus, Corel X4, Photograv, design shop pro
Knight DC16, DK3 Mug Press, Hix HD400D, GX7000
Embroidery
Hot stamping
Send me a PM what is needed and i will typeset it for you.