With eveything glued up I started profiling today. Hereare the top and back with the template traced out on them...
And, after rough cut on the bandsaw.
I gave the top of the back a quick blocking to knock down any height differences in the joint.
I attached the template and made 3 shallow passes with a pattern bit. I'll flip the body and finish it out with a flush trim bit. While I had the template in place, I traced out the other routes...not for routing at this point, but for a reference later.
I don't have a piloted bit this small, so I used my truss rod setup to route the channel between control cavities.