Hey all...I'm sure this is out there somewhere but not finding it this morning.
I understand the potential risks of PVC over metal however, performance wise is there much of a difference if any? I'm not picturing why pvc wouldn't have the same performance as metal.
Second question is I have a 2hp delta and the intake is like 10-12" across with 3 separate 4" openings. Should I find something to replace the intake to a single 6" or maybe use 2 of the 4" and connect to one 6"? Not sure where to find something like that (replacing the entire thing w/ one 6")
My run is basically out of the DC up 10 feet and straight 18feet where most all the runs to the tools being w/in a few feet of each other. At some point I may have a need for piping going a different direction, so maybe the 4" would be enough to run one tool at a time?