Page 2 of 2 FirstFirst 12
Results 16 to 17 of 17

Thread: Router Table vs Shaper or BOTH?

  1. 01-10-2010, 5:37 PM #16
    scott vroom's Avatar
    scott vroom
    scott vroom is offline Contributor
    Join Date
    Sep 2009
    Location
    Three Rivers, Central Oregon
    Posts
    2,340
    Rod, thanks for the comprehensive answer. You mentioned "changing a router bit" on the shaper. Are there limits on which router bits can be used on the shaper? Have you found any problems running router bits on the shapper at only 10K RPM?

    Thanks-
    Scott
    Scott Vroom

    I started with absolutely nothing. Now, thanks to years of hard work, careful planning, and perseverance, I find I still have most of it left.
    Reply With Quote Reply With Quote
  2. 01-10-2010, 7:20 PM #17
    Rod Sheridan's Avatar
    Rod Sheridan
    Rod Sheridan is offline Contributor
    Join Date
    Dec 2006
    Location
    Toronto Ontario
    Posts
    11,272
    Hi Scott, I've used router bits down to about 1/2" diameter.

    I have very few router bits, however recently I borrowed a rail and stile set and it worked just fine.

    Regards, Rod.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules