Could someone please convert this to X3?
Thanks
http://www.instructables.com/id/S4I4E26G0IPLU49/
Could someone please convert this to X3?
Thanks
http://www.instructables.com/id/S4I4E26G0IPLU49/
-Garrett Nors
45w Epilog Helix ♦ Dahlgren Wizzard 2000ST (currently down for the count) ♦ CorelDRAW X3 ♦ Adobe Illustrator & Photoshop CS4
I`ll do it but i am not a member
mail it to me
Bjorn
The DXF file didn't open for me. It just opens another web page.
The DXF file is just blank...I have tried importing it into both AI and CD, with no success. I have attached the X4 file. Thanks!
-Garrett Nors
45w Epilog Helix ♦ Dahlgren Wizzard 2000ST (currently down for the count) ♦ CorelDRAW X3 ♦ Adobe Illustrator & Photoshop CS4
Here it is:
http://www.afetrophyshop.com/misc/docker.dxf
-Garrett Nors
45w Epilog Helix ♦ Dahlgren Wizzard 2000ST (currently down for the count) ♦ CorelDRAW X3 ♦ Adobe Illustrator & Photoshop CS4
Here you go. You should check some sizes as I used AutoCAD version 10 to read it into CAD then saved it. Corel may have made some assumptions.
It is in Corel v9 I had to zip it was it was too big for an attachment.
Dave J
Forums: Where all too often, logic is the first casualty.